LUMITRONIX constant current source

Constant current source for operating LEDs with a current of 700mA. Constant current sources are particularly well suited to safely and professionally operate one or more LEDs. Especially when the input voltage is not constant (alternating current), constant current sources offer a way of operating LEDs directly from this current source without great effort. Protection circuits for short circuit, overload and overheating with interruption of the circuit and automatic reset after the fault has ended. The device has a very flat design, is suitable for furniture installation, TÜV tested and has low interference emissions.

features

• The constant current source is suitable for delivering power from 0W to 12W
• constant voltage source design
• Universal AC input 200-240 VAC
• switching power supply
• Protection circuit: short circuit, overload, overheating, open circuit
• Automatic reset after the error has ended
• Low interference emission
• Flat design
• Suitable for installation in furniture
• TÜV tested (EN 61347-1:2008, EN 61347-2-13:2006)
• Dimensions (LxWxH): 127x50x12mm

The LED power supply has been developed exclusively for the operation of LEDs. The power source may only be used indoors.

Important instructions

• Protect the constant current source from excessive heat input.
• The constant current source is suitable for delivering power from 0W to 12W.
• Connect the LEDs in the correct polarity as shown in the pictures.
• First connect the constant current source to the LEDs and then switch on.
• Do not exceed 2m cable length for the connecting cables to the LEDs.
• Long lines can negatively affect the radiation behavior.
• If the constant current source is used for a purpose other than that stated or is incorrectly connected, no liability can be accepted for further damage.